Ega Master EGATRONIK Manual De Instrucciones página 17

Receiving Light Source Outside (see figure)
1. Position the Meter on a flat place. Hold the Meter50~200mm and at the vertical angel not
greater than30° from the Tachometer light source to the object under test.
2. Set up the Meter, object under counts and outside lightsource as figure.
3. Press ON/OFF button
4. Turn the LED off, refer to page 9 point B.
5. Then press R/C button to select Counts mode.
6. The object under count passes through between theMeter and the outside light source, the
Meter accumulates the counts and displays quantity.
Note:
1. Under the count mode, when the quantity is greaterthan 99999 RPM, the Meter displays
OL and hold thedata.
2. Press M/M/A button zeroing the Counts.
3. Press ON/OFF to re-start Counting.
C. Data Transferring and USB (Code 51265 only, see figure)
Connect the USB interface cable, the Meter and the computer as per the figure:
17