Hoshizaki KMD-210AB-HC Manual De Instrucciones página 4

I. INSTALLATION INSTRUCTIONS
1. UNPACKING
Children should not be allowed in reach of the packaging elements
(plastic bags and expanded polystyrene) as they are potential
sources of danger.
Remove shipping carton, tape(s) and packing. If packing material
is left in the icemaker, it will not work properly.
Top Insulation
Thumbscrews
Front Insulation
Front Panel
Screws
1) After removing the packaging, make sure that the icemaker is in good
condition. If in doubt, please do not use the equipment but apply to
professionally qualified personnel.
2) Remove shipping tape holding the components.
3) Remove the protective plastic film from the exterior. If the icemaker
is exposed to the sun or to heat, remove the film after the icemaker
cools.
4) Remove the package of accessories, and check the contents:
a) Power Supply Cord
b) Mounting Bracket
c) Bolt
2. LOCATION
1. This icemaker is not intended for outdoor use. Normal operating
ambient temperature should be within 7°C to 40°C. Normal
operating water temperature should be within 7°C to 35°C.
Operation of the icemaker, for extended periods, outside
of these normal temperature ranges may affect production
capacity.
2. The icemaker should not be located next to ovens, grills or
other high heat producing equipment.
3. The location should provide a firm and level foundation for the
equipment.
4. Allow 15 cm clearance at rear, left side and top and 30 cm
clearance at right side for proper air circulation and ease of
maintenance and/or service should they be required.
5. This appliance is not suitable for installation in an area where
a water jet could be used and where dripping is not allowed.
6. Do not place anything on top of the icemaker or in front of the
louver.
7. This icemaker will not work at subfreezing temperatures. To
prevent damage to the water supply line, drain the icemaker
WARNING
CAUTION
Top Panel
Side Frame
Screw
Side Panel
Front Frame
Fig. 1
1
2
2
IMPORTANT
when air temperature is below zero (see "II. 2. PREPARING
THE ICEMAKER FOR LONG STORAGE").
8. Avoid prolonged exposure of the appliance to direct sunlight.
3. INSTALLATION
* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer cannot
be held responsible.
* Place the icemaker on top of the storage bin/dispenser
unit by holding the bottom.
* Place the icemaker in the selected permanent site.
* The appliance must be positioned so that the plug is
accessible.
* Level the dispenser unit/ice storage bin in both the
left-to-right and front-to-rear directions. If using an ice
storage bin, adjust the ice storage bin legs to level.
See Fig. 2.
4. BIN CONTROL INSTALLATION
1) Remove the front panel, then remove the front insulation.
2) Loosen the two thumbscrews securing the pump motor bracket. See
Fig. 3.
Discharge
Hose
Pump Motor Bracket
3) Disconnect the discharge hose.
4) Disconnect the pump motor connector and float switch connector
from the side of the control box.
5) Pull out the water tank, cube guide, pump motor bracket, pump motor
and float switch together. See Fig. 4.
Cube Guide
3
ENGLISH
Max. 5mm
Fig. 2
Float Switch
Connector
Pump Motor
Connector
Thumbscrews
Snap Tab
Fig. 3
Pump Motor
Float Switch
Snap Tab
Fig. 4