Error Messages - Korg GRANDSTAGE 73 Manual De Usuario

Ocultar thumbs Ver también para GRANDSTAGE 73:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

I hear noise.
□ One effect used by programs is a noise-like effect, called
"Analog Record". The resonance filter may also be used to
make the sound resonate. In either of these cases, this is not a
malfunction.
□ When raising the volume using the DYNAMICS knob,
EQUALIZER slider, LEVEL knob and other controls, the
levels may become excessive due to signal processing,
which might result in a distorted or noisy sound. This is not a
malfunction.
Adjust this by turning down the levels for each section.
□ When the REVERB/DELAY section is on, the sound may
be distorted or noisy due to excessive input. This is not a
malfunction.
Adjust this by lowering the LEVEL knobs on the
KEYBOARDS and ENSEMBLE sections, and by lowering
the value on the Reverb Send effect parameter.
□ Some noise may occur when you change the delay effect
time using the TIME-TAP button and so on. This is because
the delay time is being abruptly changed and becomes non-
continuous. This is not a malfunction.
□ You may hear some noise as a result of a ground loop,
depending on your power supply situation. This noise may be
defeated in some cases by switching the LIFT-GND switch to
the LIFT side.
The knobs and buttons on the KEYBOARDS and
ENSEMBLE sections do not work, and I can't control
them.
□ Is panel lock on? (The EXIT (PANEL LOCK) button is
blinking in this case.)
□ Are the KEYBOARDS or ENSEMBLE buttons off (dark)?
I made a favorite by modifying its program or making
other edits, but it's no longer there.
□ You may have switched to another favorite or turned off the
power before saving your favorite.
The damper pedal, expression pedal and foot switch
connected to the FOOT CONTROLLERS jacks don't
work as intended.
□ Are you using the correct settings when connecting the
pedals? Use the Calibration function to adjust the polarity and
variable range.
MIDI transmit and receive is not working correctly
with external devices.
□ Are the MIDI cables connected correctly?
□ If connecting via USB-MIDI, is the USB cable correctly
plugged in to the USB B port?
□ Is the Grandstage set to transmit and receive MIDI data on the
same channel as the external MIDI device?
□ Are MIDI messages being transmitted and received that are
compatible with the Grandstage?
The Grandstage is not responding to MIDI program
change messages.
□ The Grandstage supports MIDI program change messages
for selecting favorites. However, sound programs on the
KEYBOARDS and ENSEMBLE sections cannot be selected
using MIDI program change messages.
The DYNAMICS knob does not respond to MIDI input.
□ The Dynamics function only works on notes that are played
using this keyboard. Dynamics has no effect on notes received
via MIDI IN.

Error messages

No valid media
Refer to "Storage media that can be used" on page 19, "Save
.FAV File (saving the favorite data)" on page 18, and "Load
.FAV File (loading the favorite data)" on page 19.
No File/Path
Refer to "Save .FAV File (saving the favorite data)" on
page 18.
No free space
Refer to "Storage media that can be used" on page 19.
Save Error
An error occurred when writing to media while executing "Save
FAV File". The media may become unusable if it is ejected during
a save operation, and data may not be able to be saved to it. Use
a computer to back up the data as necessary, and repair the media
by reformatting it or by other means.
Write Protected
The media where you attempted to write data is write protected.
Disable write protect on the media, and execute the command
once again.
21

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Grandstage 88

Tabla de contenido