Korg GRANDSTAGE 73 Manual De Usuario página 5

1 2 3 4 5
EDIT button (see page 13)
Enters Edit mode for the program. When this happens, the
button will light up.
9. WRITE button (see page 13)
The current sound settings can be saved to the favorites.
10. SWAP button (see page 13)
When this button is pressed (the button will light) while
the keyboard is in split sound mode, the lower part of
the keyboard (lower note range) will be switched to the
KEYBOARDS program, and the upper part of the keyboard
(higher note range) will be switched to the ENSEMBLE
program.
11. SPLIT button (see page 12)
When this button is pressed (the button will light), the
keyboard will be split into two different sounds. This button
is also used to set the split point.
12. FAVORITE (Favorite section)
(see page 8) (see page 12)
One of 64 favorite saved sounds to use can be selected.
Favorites can be quickly selected through a combination of
the A–H buttons and 1–8 buttons.
13. KEYBOARDS (Keyboard section) (see page 9)
This section is used to select and edit keyboard instrument
programs in the KEYBOARDS category, such as pianos,
electric pianos, organs and so on. Programs selected and
parameters edited here can be saved as favorites.
KEYBOARDS button
Turns KEYBOARDS programs on (the button will light) or
OFF (the button will go dark). The KEYBOARDS sounds
will not be heard when the button is off.
Category selection knob
Selects the KEYBOARDS program category.
Display
Shows the program name and parameter values while in Edit
mode.
VARIATION knob
Selects programs within categories, as well as parameters
while in Edit mode.
LEVEL knob
Adjusts the volume of the program. The volume level is
shown by the LEDs surrounding the knob. Also, this knob
is used to set the values for the parameters shown on the
display in Edit mode.
EDIT button (see page 13)
Enters Edit mode for the program. When this happens, the
button will light up.
6 7 8
13
9 10 11
14. REVERB/DELAY (Reverb/Delay section)
(see page 15)
Sets the reverb and delay effects. The settings can be saved
as favorites.
REVERB/DELAY button
Turns reverb and delay effects on (the button will light) or
off (the button will go dark).
Effect selection knob
Selects the reverb or delay effect type.
DEPTH knob
This sets the depth of the effect. The setting value is shown
by the LEDs surrounding the knob.
TIME-TAP button
Set the reverb time or delay time, according to the intervals
at which you press the TAP button.
15. EXIT (PANEL LOCK) buttton
Pressing this button quickly will activate the Exit function.
This is used to cancel a favorite write operation, and can also
be used to exit the Panel Lock function, edit mode, navigate
out of the system settings and so on.
Hold this button down for about 1 second to turn on the
Panel Lock function. The button will blink (see page 11).
16. SYSTEM button (see page 15)
Press this button to access the overall settings for the
Grandstage, such as master tune, MIDI, the Control function,
sound data restore and so on. When this is on, the button will
blink.
17. TRANSPOSE button (see page 11)
Adjusts the overall pitch in semitones, over a range of one
octave up or down. Press a key from C3 to C5 while holding
down the button to transpose the pitch.
14
15
16
17
12
5