Making Connections And Installing The Driver; Windows Xp/2000 Users - Edirol UA-1X Manual Del Usuario

Connections and Driver Installation (Windows)

Making Connections and Installing the Driver

The installation procedure will differ depending on your
system. Please proceed to one of the following sections,
depending on the system you use.
• Windows XP/2000 users ...................p. 14
• Windows Me users .............................p. 15
• Windows 98 users...............................p. 16
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before disconnecting the USB cable.
It is not necessary to turn off the power of your computer.
Use a USB cable to connect the UA-1X to your computer
before turning on the power of your audio equipment.

■ Windows XP/2000 Users

1
With the UA-1X disconnected from your computer,
turn on your computer and start up Windows.
Disconnect all USB cables except for a USB keyboard and
USB mouse (if used).
2
Use a USB cable to connect the UA-1X to your
computer.
The UA-1X will be detected automatically, and the driver will
be installed.
3
After installing the driver, restart Windows.
Next, you need to make the driver settings.
→ Settings and Checking (p. 19)
14
If you are using Windows XP,
the installation has been
completed when the message
near the taskbar saying that
"Found New Hardware"
has disappeared.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.