Audio Software Settings - Edirol UA-1X Manual Del Usuario

figmacX-2, macOSX-3.
5
If the Input tab is
displayed, choose USB
Audio CODEC as the
device for inputting
sounds.
Known issues: UA-1X
Caution
Please check the following before you use your software.
• Use a USB cable to connect the UA-1X to your computer before you
start up your software.
• Do not disconnect the UA-1X's USB cable while your software is
running.
• Exit your software before you disconnect the UA-1X's USB cable.
• Turn off the Sleep settings of your Macintosh.
• The UA-1X will not operate in the Mac OS X Classic environment.
You can not use it if the Classic environment is running.

■ Audio Software Settings

Use a USB cable to connect the UA-1X to your computer
before you start up your software.
If your software allows you to make audio input/output
settings, choose USB Audio CODEC.
* For details, refer to the owner's manual of the software you
are using.
Known issues: UA-1X
• While the audio application is recording or playing, do not connect/disconnect
the USB cable. Doing so may cause the application to freeze.
• You may hear sound hopping and/or noise when you record and play back at the
same time due to high load on the CPU. However, the noise should not be in the
recording itself. Such noise should only be found in the playback signal.
• The standard driver that comes with Mac OS is not ASIO compatible.
Connections and Driver Installation (Macintosh)
29