Panel Descriptions - Edirol UA-1X Manual Del Usuario

Panel Descriptions

fig.01-08_90
8
1
Input select switch
Set this switch appropriately for the device that
you connect to the input jacks. Normally, you will
leave this at the LOW setting. If the sound is
distorted because the signal level is high, set this
to HIGH.
2
Line input jacks
Make connections here when you want to input
audio signals from an audio device or MIDI
sound generator.
3
Line output jacks
Connect these to your audio equipment (AUX IN,
LINE IN), such as an AV amp or stereo system.
Output level indicator,
4
Input level indicator
The INPUT indicator will light when audio
is received through the line input jacks. The
OUTPUT indicator will light when audio is
output from the line output jacks.
5
Headphones volume
This adjusts the volume that is output from the
Headphone jack .
St e r e o set
( C asset t e , r e cor d pl a yer )
UA- 1 X Loop Connect i o n
6
I N PUT LI N E OUT
OUTPUT LI N E I N
You cannot adjust the volume of the signal that
is output from the digital output jack.
8
1
2
6
7
6
Headphone jack
A set of headphones can be connected here. Even
if headphones are connected, sound will still be
output from the Line output jacks
6
Digital output connector (optical)
If you want to digitally output the audio signal
to a Dolby Digital decoding amp or to a digital
recorder such as an MD, use an optical cable
to make connections.
* The same jack serves as both the
headphone jack and digital output jack.
Optical
These are digital I/O jacks for connecting optical
cables. Digital I/O jacks for connecting coaxial
cables are labeled Coaxial.
7
USB indicator
This will light when the UA-1X is connected and
recognized to the computer.
8
USB cable
Connect this cable to the USB connector of your
computer.
3
5
.
3