Maintenance And Checks Of The Safety Devices On The Product; To Do A Check Of The Front Hand Guard; To Do A Check Of The Brake Trigger - Husqvarna T535i XP Manual Del Usuario

Maintenance
Clean the chain brake and make sure that it operates safely. Make sure that the
chain catcher is not damaged. Replace it if necessary.
Turn the guide bar for more equal wear. Make sure that the lubrication hole in
the guide bar is not clogged. Clean the bar groove.
Make sure that the cutter and cutter guard have no cracks and that they are not
damaged. Replace the cutter or cutter guard if they have cracks or if they have
been exposed to impact.
Make sure that the guide bar and saw chain have sufficient oil.
Do a check of the saw chain. Look for cracks and make sure that the saw chain
is not rigid or unusually worn. Replace if necessary.
Sharpen the saw chain. Do a check of its tension and condition. Do a check for
wear on the drive sprocket and replace is necessary.
Clean the air inlet on the product.
Make sure that the screws and nuts are tight.
Make sure that the keypad works correctly and that it is not damaged.
Use a file to remove burrs from the edges of the guide bar.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Empty and clean the oil tank.
Blow through the product and battery cooling slots gently with compressed air.
Maintenance and checks of the safety
devices on the product

To do a check of the front hand guard

Regularly do a check of the front hand guard.
1. Make sure that the front hand guard is not damaged
and that there are no defects, such as cracks.
18
2. Make sure that the front hand guard moves freely
and that it is attached safely to the product.

To do a check of the brake trigger

1. Start the product and make sure that the saw chain
does not touch the ground or an object. See
the product on page 14 for instructions.
Before
Weekly Monthly
use
X
X
X
X
X
X
X
X
X
X
959 - 007 -
X
X
X
To start