Accessories; Guide Bar And Saw Chain Combinations - Husqvarna T535i XP Manual Del Usuario

Low energy mode
Lubrication system
Type of oil pump
Oil tank capacity, US Pint/litre
Weight
Chainsaw without battery, guide bar, saw chain and empty chain oil tank,
lb/kg
Water protection level
IPX4
Saw chain/guide bar
Recommended bar lengths, inch/cm
Usable cutting length, inch/cm
Type of drive sprocket/number of teeth
Maximum chain speed / (savE), m/s
Recommended cutting equipment for
USA
Following is a list of recommended cutting equipment for
Husqvarna T535i XP. This model equipped with either of
the listed guide bar and saw chain combination(s), fulfills
the requirements according to UL 1662-2009 and UL
60745-1-11.
Chainsaw model Husqvarna T535i XP met the kickback
performance requirements of ANSI B175.1-2012 when
tested with the combinations of bars and saw chains
listed below. The saw chain Husqvarna H38 is also
classified as a low kickback saw chain since is met the
requirements for low kickback saw chain outlined in
ANSI B175.1-2012. We recommend to use only the
listed combinations of bars and saw chains for chainsaw
models Husqvarna T535i XP. Other chainsaw models
may not meet the kickback requirements when equipped
with the listed bar and saw chain combinations.

Guide bar and saw chain combinations

Following is a list of recommended cutting equipment for
Husqvarna T535i XP. The listed combination(s) of
959 - 007 -

Accessories

powerhead, guide bar and saw chain meet all
requirements outlined in Canadian Standards
Association Z62.1-11 (Chain saws) and Z62.3-11 (Chain
Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated
and listed as a Type C Low Kickback Saw chain
according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna T535i XP.
T535i XP
savE
Automatic
0.42/0.2
5.3/2.4
Yes
10-14/25-35
9-13/23-33
Spur/7
20 (15)
27