the power trigger and the power trigger lockout move
back to their initial positions.
Chain catcher
The chain catcher catches the saw chain if it breaks or
comes loose. If you have the correct chain tension, the
risk decreases. You also decrease the risk if you do the
correct maintenance on the guide bar and saw chain.
Assembly on page 11 and Maintenance on page
See
17 for instructions.
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
•
Only use the BLi batteries that we recommend for
your product. The batteries are software encrypted.
•
Use the BLi batteries that are rechargable as a
power supply for the related Husqvarna products
only. To prevent injury, do not use the battery as a
power supply for other devices.
•
Risk of electrical shock. Do not connect the battery
terminals to keys, screws or other metal. This can
cause a short circuit of the battery.
•
Do not use batteries that are non-rechargable.
•
Do not put objects into the air slots of the battery.
•
Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
•
Keep the battery away from rain and wet conditions.
•
Keep the battery away from microwaves and high
pressure.
•
Do not try to disassemble or break the battery.
•
Do not let battery acid touch your skin. Battery acid
causes injuries to the skin, corrosion and burns. If
you get battery acid in your eyes, do not rub but
959 - 007 -
A
B
flush with water for minimum 15 minutes. If battery
acid has touched your skin, you must clean the skin
with a large quantity of water and soap. Get medical
aid.
•
Use the battery in temperatures between -10 °C (14
°F) and 40 °C (104 °F).
•
Do not clean the battery or the battery charger with
To do a check of the battery and the
water. See
battery holder on page 20 .
•
Do not use a defective or damaged battery.
•
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
•
Keep the battery away from children.
Battery charger safety
WARNING: Read the warning instructions
that follow before you use the product.
•
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
•
Use an approved grounded mains socket that is not
damaged.
•
Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
•
Do not try to disassemble the battery charger.
•
Do not use a defective or damaged battery charger.
•
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
•
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or similar.
•
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
•
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
•
Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
•
Do not put objects into the cooling slots of the
battery charger.
•
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
•
Use approved wall sockets that are not damaged.
•
Use only three-wire outdoor extension cords that
have three-prong grounding plugs and grounding
receptacles that accept the appliance's plug.
9