To Charge The Battery; To Start The Product; To Set The Optimal Airflow For Your Work; To Do A Function Check Before You Use The Product - Husqvarna 320iB Manual Del Usuario

To charge the battery

Note: Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Connect the battery to the battery charger.
2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
3. When all LEDs on the battery come on, the battery is
fully charged.
3
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
To do a function check before you
use the product
1. Do a check of the air inlet for dirt and cracks. Use a
brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
10
2 1

To start the product

1. Move the ON/OFF switch lever to ON position.
2. Use the power trigger to control the speed.
To set the optimal airflow for your
work
1. Move power trigger control to increase or decrease
the airflow.
2. Use position 1 to blow very gently. This mode can be
used for indoor use.

To temporarily increase the airflow

This mode is used only on occasions when leaves and
trash is blocked or when the usual airflow is not
sufficient. In most conditions, usual airflow is sufficient.
An increasing airflow is used mainly for brief measures.
Temporary increasing of the airflow can be used in all
power trigger settings.
1. Press the power trigger to get a temporary increased
airflow.
2. The airflow increases for approximately 10 seconds
and then goes back to usual airflow.
800 - 001 - 31.08.2018