Assembly; Operation - Husqvarna 320iB Manual Del Usuario

SAVE THESE
INSTRUCTIONS
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the tube on the product
1. Put the blower nozzle over the tubular end of the
product.
2. Push the blower nozzle in fully and turn the blower
nozzle to lock it to the product.
To connect the battery to the
product
WARNING: Only use Husqvarna original
batteries in the product.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
800 - 001 - 31.08.2018

Assembly

1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it is not
installed correctly.
3. Press the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock into position when you hear a click.
4. Make sure that the latches snap in place correctly.

Operation

To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F.
9