Safety Considerations; International Symbols; Terminology; Warnings - Temper KOBAN KCER-01MF Manual Del Usuario

KCER-01MF
Multifunction Tester
WARNING!
You must read and completely understand the Safety Considerations part of this manual before using
the instrument.

1. SAFETY CONSIDERATIONS

This manual contains instructions regarding the safe use and the proper functioning of the instrument. If
not
complied with, the user could be exposed to danger and the instrument to possible damage.

1.1. International Symbols

: WARNING!
: CAUTION! Voltage present
: Earth
: Double Insulation (Class II insulation)
: Fuse
: Prohibited to use for the Electrical System which uses the voltage above 550V
: Conformity to European Standards

1.2. Terminology

The term WARNING as used in this manual defines a condition or a procedure which could lead to a serious
injury or accident. The term CAUTION defines a condition or action which could lead to the instrument being
rendered defective during the testing process.

1.3 Warnings

Make sure to read and fully understand the instruction contained within this manual prior to use.
This instrument is not intrinsically safe therefore do not use the instrument in hazardous
environments.
In order to prevent fire and/or electrical shock, do not use the instrument in wet, damp or highly
humid environments.
Prior to use, check if the instrument functions correctly. If any symptoms/symbols of malfunction or
abnormalities are indicated, do not use and inform MTi Instruments.
Users who could be exposed to voltages in excess of the extra low band (50V ac or 120V dc) should
be competent and be aware of the requirements of GS 38 regarding the use of the instrument and
the associated leads and probes etc.
Make sure your fingers holding the test probes are positioned behind the safety lines of the test
probes.
DO NOT OPEN THE INSTRUMENT.
If the internal fuse (protective device) operates, replace with a device of the same type and rating.
If it operates again seek professional advice. DO NOT REPLACE FUSE AND TRY AGAIN.
When carrying out the "dead tests" ensure prior to connection of the instrument leads the circuit
under test has been confirmed "dead" and secured in the OFF position using appropriate methods.
Battery condition is indicated by a beep. Check and replace if necessary.
Do not test an electrical circuit or systems where the voltage is in excess of 550V.
Ensure at all times the leads are in compliance with GS 38 (as supplied) and not damaged.
3
www.grupotemper.com