To Install The Collection Bag With Different Vacuum Tubes; Operation - Husqvarna 125B Manual De Usuario

1. Align the rib on the upper blower tube with the
groove in the blower outlet. Move the tube into
position.
2. Turn the bolt clockwise with a screwdriver to attach
the tube.
Note: Do not use any tool on the nut.
3. Align the slots on the lower blower tube with the tabs
on the upper blower tube. Move the lower blower
tube onto the upper blower tube.
4. Turn the lower blower tube clockwise until there is a
click.
To install the collection bag with
different vacuum tubes
WARNING: Turn off the engine before you
attach the the tubes to the product.
To assemble the collection bag
1. Open the collection bag.
2. Insert the collection bag tube from inside of the bag
to fit in the vacuum inlet opening.
3. Make sure that the elastic seats in the groove (A).
4. Close the zipper on the bag. (Fig. 18)
To install the collection bag tube
1. Remove the blower tube, if it is attached.
2. Align the rib on the collection bag tube (A) with the
groove in the blower outlet (B).
WARNING: Read and understand the safety
chapter before you operate the product.
Fuel
To use fuel
CAUTION: This product has a two-cycle
engine. Use a mixture of gasoline and two-
cycle engine oil. Make sure to use the
correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Gasoline
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
10
3. Push the collection bag tube fully onto the blower
outlet.
4. Insert the nut (C) in its opening.
5. Install the screw (D) and tighten with a screwdriver to
attach the tube. (Fig. 19)
To attach the vacuum tubes together
1. Align the arrow on the lower vacuum tube (A) with
the arrow on the upper vacuum tube (B).
2. Push the lower vacuum tube into the upper vacuum
tube.
3. Use a screwdriver to install the self-tapping screw
(C) that holds the tubes together. (Fig. 20)
To install the vacuum tubes
1. Insert the tip of a screwdriver into the latch area of
the vacuum inlet.
2. Turn the screwdriver to release the latch. (Fig. 21)
3. Hold the vacuum inlet cover open until the upper
vacuum tube is in place.
4. Align the ribs on the inside of the vacuum inlet with
the slots on the upper vacuum tube. Make sure the
lock symbol on the tube aligns with the unlock
symbol on the vacuum inlet. (Fig. 22)
5. Push the upper vacuum tube fully onto the vacuum
inlet.
6. Turn the upper vacuum tube clockwise until the lock
symbol on the tube aligns with the lock symbol on
the vacuum inlet. The tube makes a click when it is
correctly attached. (Fig. 23)

Operation

CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). This
can cause damage to the product.
CAUTION: Do not use leaded gasoline. This
can cause damage to the product.
• Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
• Always use a good quality unleaded gasoline/oil
mixture.
Two-cycle engine oil
• Use only high quality two-cycle engine oil. Use only
an air cooled engine oil.
• Do not use other types of oil.
237 - 009 - 16.12.2019