Carrying Out A Connection Test; Alarm-Attenuation Ring - Dräger X-zone 5500 Instrucciones De Uso

8. If the displays are outside of the above-mentioned ranges:
Check whether the cap is dirty and clean it if necessary

(see chapter 13 on page 71).
If necessary, replace the gas inlet filter (see chapter

12.2.2 on page 69).
If necessary, adjust the X-am 5100 (see Instructions for

Use of the X-am 5100).
3.5

Carrying out a connection test

The connection test can be used to check the correct
connection to all X-zone 5500 devices.
To perform a connection test:
1. Press the key to open the menu.
OK
2. Use the key to select
and confirm the function
to start the connection test.
A signal via horn and LED
ring is issued three times
on every device connected
wirelessly or via a cable.
NOTICE
i i
The relay contact can also be connected as an option.
The setting can be configured using the Dräger CC-
Vision PC software (see chapter on page 64).
Dräger X-zone 5500
3.6

Alarm-attenuation ring

WARNING
!
The alarm-attenuation ring must not be used in
explosion-hazard areas!
When switching off, on during and the functional tests of the X-
zone 5500, Dräger recommends wearing hearing protection or
using the alarm-attenuation ring (order no. 83 20 110) since
the acoustic alarm is activated briefly.
04833112.eps
Operation
03033112.eps
47