Chapter 7 - Text Messages - Wolf Garten Robo Scooter 500 Instrucciones De Servicio Originales

Chapter 7 - Text Messages

3
Note
Robo Scooter 500 is equipped with an LCD panel that will no-
tify you in the form of a text message when common operatio-
nal faults occur to instruct the user to perform a certain function
or action.
z If the LCD screen is blank, pressing the 'GO' button one
time will wake the mower up and the last fault or message
displayed prior to stopping will now be displayed.
z If a specific problem re-occurs, it is recommended to iden-
tify the fault code prior to calling for service. Pressing the
'UP' arrow once, while the message is displayed, is a short-
cut button to display the 'Last stop cause'
Message
Probable Cause/Event
Displayed
Adjust wire then • Robo Scooter 500 detects an obstacle along the edge
press GO while operated in 'Wire position test' mode.
• Robo Scooter 500 fails to enter the Base Station 3
Base problem
times continuously
Bumper pressed • Bumper is constantly being pressed
• This message appeared at the first time the 'GO' but-
Change wires in ton is pressed after completing the setup in case the
plot connector perimeter wire is connected to the plot connector in
the wrong polarity.
Charging failure • The charging process is not active
• Mowing motor has faced over-current for too long be-
cause of high grass or some obstacle is stuck or wrap-
ped around the blade.
• Something is preventing a blade from rotating freely.
Check mow height
Severe grass accumulation under the mowing deck;
rope or similar object wrapped around mowing blade.
• Object jammed under mower preventing blade from
rotating.
• Power supply is not plugged properly into the main po-
wer supply
• The charging process has stopped due to a temporary
power loss.
• No power to receptacle or main power is shut off
Check power (Ba-
se Station)
• The mower or Charging Station contacts are dirty.
• Charging is not detected, although there is physical
contact between the mower and the Base Station con-
tacts.
• Power supply cable is not plugged properly into the
mains supply.
Check power
(Winter charger)
• No power to receptacle or main power is shut off.
50
Corrective/User Action
• Adjust the wire in the place where it collides in the obstacle
or remove the obstacle and then press 'GO' to continue in
the wire position test.
• Adjust the Base Station position.
• Clean the contacts with a brush or piece of cloth.
• Confirm a good connection of the cables to the Base Station
contacts.
• Confirm the Base Station is leveled with the ground before
the Base, so there is no step that causes Robo Scooter 500 to
slips.
• Move mower away from object pressing against bumper.
• Change between the two wires ends that connected to the
plot connector (the green connector that connected to the
Base Station).
• Contact service provider
1
Attention!
Remove fuse before lifting the mower.
• Inspect blades for foreign material or debris preventing rota-
tion.
• Clean out accumulated grass clippings using a wooden
stick.
• Confirm power supply is plugged into the main power recep-
tacle.
• Turn power on to the main receptacle.
• Check the mains supply using another appliance .
• Clean the contacts with a brush or piece of cloth.
• Confirm a good connection of the power supply to the Base
Station.
• Confirm a good connection of the Base Station board cables
(green and red) to the Base Station contacts pins (screws
are tightened).
• Confirm power supply is plugged into the main power recep-
tacle.
• Turn power on to the main receptacle.
• Check the mains supply using another appliance
en