Operating Mode; Maintenance Instructions - Desoutter ELRT025-P4600-10S Manual De Uso

English
B TOP CABLE TOOL DESCRIPTION
1 Ouput
2 Trigger
3 Reverse
4 LEDs
5 Suspension
CHANGING TOP CABLE
C
ORIENTATION

OPERATING MODE

Make sure that the tool is in perfect
working order and the controller is
programmed correctly, to reduce the
risk of injury to the operator as a result
of unexpected behaviour of the tool.
For 10S models
Use specific guided sockets in order
to have the tool working at its best
performances.
● Fit the tool with a suitable fastening
accessory, then plug it to the controller.
● Select the appropriate program on the
controller.
● Hold the tool by means of the handle and
apply to the fastener to be tightened.
● Press the trigger to start the tool.
● For a reverse rotation, press the reverse
button and apply the tool to the fastener.

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task:
- switch off the controller.
- disconnect the tool.
Overhaul and preventive maintenance
is recommended at regular intervals
once per year or after maximum 500,000
tightenings depending on which occurs
sooner.
09/2019
Assembly and disassembly
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● When disassembling the tool front assemblies,
take care for the torque transducer wires.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
Tool cable servicing
If the tool cable is damaged, contact your
Desoutter representative to have it replaced or
consult the website www.desouttertools.com to
find out where you can have it done.
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
Lubrication
● Do not apply too much grease on gears or
bearings; a thin coat shall be sufficient.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
13 / 96
6159939064_01