To Clean Externally; To Clean The Cold Air Intake; To Examine The Spark Plug; To Do A General Inspection - Husqvarna K1270 II Manual Del Usuario

To clean externally

• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.

To clean the cold air intake

Note: A dirty or blocked air intake makes the product too
hot. This can cause damage to the piston and cylinder.
• Clean the cold air intake if it is necessary.
• Remove blockage, dirt and dust with a brush.

To examine the spark plug

Note: Always use the recommended spark plug type.
Use of the incorrect spark plug can cause damage to the
piston and cylinder. For recommended spark plug refer
# .
to
Examine the spark plug if the product is low on power,
does not start easily or if it operates unsatisfactorily at
idle speed.
1. Loosen the 3 screws on the air filter cover and
remove the air filter cover.
28
2. Make sure that the spark plug cap and ignition cable
are not damaged to prevent the risk of electrical
shock.
3. Clean the spark plug if it is dirty.
4. Make sure that the electrode gap is 0.5 mm.
5. If it is necessary, replace the spark plug.

To do a general inspection

• Make sure that all nuts and screws on the product
are tightened correctly.

To replace the drive belt

WARNING: Do not start the engine when the
belt pulley and the clutch are removed for
maintenance.
WARNING: Do not start the product without
the cutting arm or the cutting head installed.
988 - 002 -