Publicidad
Idiomas disponibles
Idiomas disponibles
To clean the product
WARNING:
When you clean with a high-pressure
washer, dirt and harmful material can eject
from the product.
•
Let the product become cool before you clean it.
•
Make sure that the cover for the relay and fuse box
is correctly installed before you clean the product.
•
Do not clean electrical components with water.
•
Use a weak cleaning agent. Put on protective gloves
to prevent skin irritation.
•
Use a high-pressure washer to clean the product.
To clean the radiator
CAUTION:
Incorrect procedure can cause damage to
the cooling fins.
•
Use compressed air to clean the cooling fins.
•
If it is necessary, use a high-pressure washer and a
weak cleaning agent.
•
Spray directly on the radiator, in parallel to the
cooling fins.
•
Keep a minimum distance of 40 cm/15.75 in.
between the cooling fins and the nozzle for the high-
pressure washer or air flow.
To clean the control panel
CAUTION:
washer to clean the control panel.
•
Clean electrical components with a cloth or with
compressed air.
•
Clean the control panel with a moist cloth.
To clean the engine
•
Keep a minimum distance of 40 cm/15.75 in.
between the nozzle and the engine and engine
components.
•
Be careful when you clean the engine, especially
near electrical components. Do not spray water
directly at electrical components.
•
Do not point the water directly into the exhaust pipe
or the engine air filter.
To do after you clean the product
•
Blow electrical terminals dry with compressed air.
•
Let the product become fully dry before you start the
engine.
1657 - 004 - 07.03.2022
Use protective glasses.
Obey the instructions.
Do not use a high-pressure
To fill fuel
CAUTION:
type. Incorrect fuel type causes damage to
the product.
1. Open the top hatch.
2. Open the fuel tank cap slowly to release the
pressure.
3. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let the remaining fuel dry off. Refer
Technical data on page 48 . For more information
to
about the fuel, refer to the engine manual supplied
by the engine manufacturer.
4. Clean the area around the fuel tank cap.
5. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
6. Move the product a minimum of 10ft/3 m from the
position where you filled the tank before a start.
To do a check of the radiator coolant
level
WARNING:
the engine become cool before you open the
radiator coolant lid.
1. Make sure that the product is level when you
examine the radiator coolant level.
2. Open the top hatch.
Always use correct fuel
Risk of burn injuries. Let
29
Publicidad
