Plunge Cuts - skilsaw SPT78MMC Instrucciones De Funcionamiento Y Seguridad

CUTTING ANGLED MATERIALS
When cutting angle materials, such as angle
iron, U-channel materials, etc., tilt the tool
back to avoid having the lower guard rest
RIGHT

PLUNGE CUTS

Disconnect plug from power source before
making ad justments. Set depth adjustment
according to material to be cut.
Hold the main handle of the saw with one
hand, tilt saw forward and rest the front of the
foot plate on material to be cut. Line up the
cutting guide notch with the line you've drawn.
With your second hand on the auxiliary han-
dle, raise the lower guard using lower guard lift
lever. (Fig. 10).
Position the saw with the blade just clearing
the material to be cut. Start the motor and
once fully up to speed, gradually lower the
back end of saw using the front end of the foot
as the hinge point.
Fig. 10
14
1619X09342.indb 14
Fig. 9
LOWER
GUARD LIFT
LEVER
FOOT
on the angle. Cut through the thinnest mate-
ial section; adjusting the cutting angle of the
blade to do so (Fig. 9).
WRONG
Once the foot plate rests flat on the surface
being cut, release the lower guard lift lever.
Proceed cutting in forward direction to end of
cut.
Allow blade to come to a
complete
lifting the saw from cut. Also, never pull the
saw backward since blade will climb out of
the material and KICKBACK will occur.
Turn saw around and finish the cut in the nor-
mal manner, sawing forward. If corners of your
plunge cut are not completely cut through, use
a jigsaw or hand saw to finish the corners.
DESIRED
LINE OF CUT
stop before
12/16/15 8:28 AM