Electric Back Adjustment (Option); Leg Supports - Vermeiren TRACER Manual De Instrucciones

function (on the G90 control unit, the selected symbol flashes). You can then adjust the slope of the
seat by pushing the joystick forwards or pulling it backwards.
L
Make sure that no objects and/or persons are inside the swinging range of the wheelchair,
either in front or at the rear, since this could cause damage and/or injury.
L
For your safety this adjust function can only be activated when all four wheels of the
wheelchair are standing still. When this function is selected, the driving program is disabled.

ELECTRIC BACK ADJUSTMENT (option)

The back can be adjusted in a similar way to the seat angle. You only have to select button the
relevant button on the steering unit and you can then tilt the back as you wish.
L
Make sure that no objects and/or persons are inside the swinging range of the wheelchair,
either in front or at the rear, since this could cause damage and/or injury.
L
For your safety this function can only be used when all four wheels of the wheelchair are
standing still. When this function is selected, the driving program is disabled.
L
Make sure that you do not set the backrest too far over backwards, since this can displace the
centre of gravity too far to the back and cause tipping over.
L
For your own safety you should not drive the wheelchair in an inclined or tilted position, since it
would severely limit your visibility.

LEG SUPPORTS

The basic model of your electric wheelchair is equipped with leg supports which allow your legs to rest
comfortably. You can adjust the length of the foot supports continuously, turn them aside, or even
remove them completely. These adjustments should be carried out by a third person with the required
technical knowledge. Consult your specialist dealer if these adjustments become necessary. If you
want to carry out these adjustments yourself, you should read the following sections carefully.
Fig. A
When you want to fix the footrests, hang one leg support sideways on the outside and then turn it
inwards until it stops. The fixing lever (Figure B) must point backwards. If the leg supports do not
engage immediately, push them lightly inwards. Do the same on the other side. To remove the
footrests, reverse this process.
L
When handling the leg supports, make sure that you hold on to the upper curve to prevent
your fingers from getting caught and hurt.
Turn the footplates out of the way for climbing in and out comfortably. The footplates are designed for
resting your feet securely on them; in addition, your feet are
unnecessarily. Use the Allen keys provided to adjust the length of the leg supports. There is a
countersunk Allen screw (Figure A) on the rear side of the leg support for fixing the footplate. By
loosening this screw the footplate can be adjusted to the length of your leg. It must be tightened
properly afterwards.
prevented from moving sideways
11
TRACER
01/2010
Fig. B
E