Changing/FItting The Diamonds - Husqvarna PG820 RC Manual De Instrucciones

Changing/fitting the diamonds
WARNING! The machine should be
!
switched off with the power cable
disconnected from the outlet.
Have a set of gloves ready, as diamond tools can get very
hot.
NOTICE! When the machine is being used, all the
grinding discs must always have the same number and
type of diamonds. The height of the diamond must be
the same on all grinding discs.
For more information, please see the 'Selecting
diamonds' section.
Have a set of gloves ready, as diamond tools can get very
hot.
• Dismantle the support wheel. For more information,
please see the 'Support wheel' section.
• Set handle in upright position.
• Fold down the foot support.
• Grab the handle bar and with one foot on the foot
support, tilt the machine backward.
• The machine should rest on its wheels and the
chassis.
28 – English
OPERATING
• Put on gloves.
• Use a hammer to remove the diamond segments.
• Affix new diamond segments on the grinding disc.
• Once new diamond segments have been attached,
reverse procedure to lower machine to ground.
Since the new diamonds may have a different height than
the ones used previously, the dust skirt must be adjusted
so that is seals against the floor.
Ensure the dust skirt is intact and clean and that is seals
against the floor. A damaged dust skirt must be replaced.