Warning Messages; Incidents During Grinding; Disturbances In Radio Communication - Husqvarna PG820 RC Manual De Instrucciones

Warning messages , remote control
• The machine has detected a fault. Go to 'ERROR LOG' to see the faults that have been detected on the machine
and possible measures to take.
REV FWD
0
SPEED
0
POWER
0
OFFSET 0
Fault Code Message on the display
0x010201 Machine battery error, contact service!
0x010202
0x010228
0x01020B Low battery level!
0x01020F Temperature in machine is too high!
0x01020E Temperature in machine is too low!
Traction overload, check that machine is not
0x010108
blocked!
0x010540 Radio error, contact service if error persists!
Temperature measurement not working, contact
0x01070D
service!
0x020202 Remote control battery needs to be replaced!
0x020228
0x020540 Internal error in remote control, contact service!
0x02000E Temperature in remote control is too low!

Incidents during grinding

Disturbances in radio communication

If the display returns to one of the home screens due to disturbances in radio communication between the remote control
and the floor grinder, a change to another radio channel can be performed. For more information, see the "Menu system
explanation", RADIO CHANNEL section.
• Make sure the STOP/RUN knob on the remote control is set to STOP (turn anticlockwise).
40 – English
TROUBLESHOOTING
SERVICE
Jan 05 12:45
REV FWD
ERROR LOG
0
SPEED
WARNING
0
POWER
Code: 0x00010201
OK
Jan 05 12:45 Jan 05 12:45
ERROR
OK
Machine battery error, contact service!
Code: 0x00010201
OK
OK
Cause
Battery not working
Battery charge short circuit
Battery charge time out
Battery low level
Machine temperature is high, battery charging is not
enabled
Machine temperature is low, battery charging is not
enabled
Traction motors are overloaded
No contact with radio
Machine temperature can not be determined.
Battery charging is not enabled
Battery charge short circuit
Battery charge time out
No contact with radio
Low temperature in remote control.