Remote Control Device Installation - TOHATSU M 25H Manual Del Propietário

Ocultar thumbs Ver también para M 25H:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENOW00008-A
CAUTION
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 Nm (3.0 kgf) 13 ft-lb)
ENOM00840-0
2. Remote control device
installation
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a position
where it is easy to reach and operate the
controls.
Make sure there are no obstacles that can
interfere with the operation of the remote
control cable.
ENOW00850-0
Remote control cable length
ENOW00100-A
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 inches)
or less. Otherwise, it affects the service life
of the cable.
Measure the distance from the remote
control box to the outboard motor where
the remote control cable should be routed.
Prepare a cable that is 300-450mm (11.8-
17.7in) longer than the measured distance.
Temporarily pull the cable along the
3
intended cable route to check its length is
sufficient.
1, 2
Connect the remote control cable to the
engine, then run the cable to the remote
control box, making sure it is not sharply
bent, too taut and free from obstructions
ENOF00841 1
that could interfere with steering.
INSTALLATION
CAUTION
ENOF00842-0
23
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M 30h

Tabla de contenido