Trailering - TOHATSU M 25H Manual Del Propietário

48
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENON00021-B
Note
If the outboard motor must be laid down
be sure drain the fuel, then the port side
faces down as shown in the following
drawing.
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
8
1. Handle
ENOM00072-A

3. Trailering

ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOF01827-0
ENOF01815-0
CAUTION
ENOW00073-A
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
ENOW00071-0
The tilt support device supplied on your
outboard motor is not intended for towing.
It is intended to support the outboard
motor while the boat is docked, beached,
1
etc.
When transporting a boat on a trailer with
the outboard motor still attached, discon-
nect the fuel line from the outboard motor
beforehand and keep the outboard motor
in the normal running position or on a tran-
som saver bar.
Tiller handle type
To prevent the outboard motor from mov-
ing when it is attached on a boat during
transport on a trailer, properly tighten the
steering friction bolt (page 50).
WARNING
ENOF00075-1
WARNING
CAUTION