Assembling The Equipment - SICE A 92 Manual De Instrucciones

Failure to observe these instructions can lead to damage to the machine and injury to
operators or other persons.
- Unpack the equipment, placing the packaging in the position shown by the markings on it.
- Unpack the personal computer.
- Remove the monitor from its packaging.
- Assemble the column (7, Fig 1), consisting of 2 parts.
- Install the shelf (2, fig.1).
- Install the PC Box (4, fig.1) and insert the PC.
- Remove the rear panel of the column.
- Connect the USB hub (HUB, Figure 2) to a free USB port on the back of the PC.
- Install keyboard, mouse and printer by connecting to the USB HUB (HUB, fig.2).
- Install the monitor stand to the monitor and mount them on the column (1, Figure 1), using the
provided screws.
-Connect the printer to the main supply via the power strip located inside the bottom of the
column.
-Connect the monitor to the PC and the power supply, through the power strip located inside the
bottom of the column.
- Mount the beam (6, Figure 1) using the provided screws.
From the lower opening of the Beam out of 4 USB type cables and 1 power type.
Bring 4 USB cables inside the PC Box through the rear hole (L1-C1-L2-C2, Fig. 2).
- Connect the 2 camera USB cable with 2 USB ports on the back of the PC (C1-C2, Figure 2).
- Connect the 2 USB cables with molded ferrite (Cuboled cards) to the USB HUB (L1-L2, Figure
2).
- Connect the Beam power cord to +12 V switching power supply output (PS, Figure 2), paying
attention to the polarity (BROWN wire = +12 V, BLUE wire = GROUND).
- Leave disconnected the cable with 9-pin connector versions without moving the beam.
- Connect the switching power supply to the power supply (PS, Fig. 2).
- Connect the PC to the mains supply (Fig. 2) via the strip placed inside the lower part of the
column.
- Connect the cables with the aid of the wiring diagram (Fig. 40); all the plugs are clearly
indicated on their respective PC sockets. Push the plugs in completely without straining and,
where applicable, tighten the lock screws.
- The aligner wheel is factory-set to operate with a mains voltage of 230Vac. The wheel aligner
may be configured to operate with a mains voltage of 115Vac.
- Refit the rear panel of the column, fastening with the specific tool provided.
- Connect the power supply cable to the plug provided; first read the "Electrical Hook-up" section.
- Turn on the aligner with the main switch and the monitor and the printer with the specific
switches.
- Update the wheel aligner software if necessary, "Updating the Wheel Aligner Software" section,
and install any optional kits, "Installing Additional Functions" section.
Insert the software protection key supplied in a free USB port of the USB HUB (SP, Figure 2).
The software protection key is required to use the aligner.

Assembling the equipment

Software protection key installation
52