Service Procedure Window; Demo; Target Test; Technical Assistance - SICE A 92 Manual De Instrucciones

6) Adjust the front axle.
7) The procedure is terminated on the Print page.
NOTE: the measurement in 2-target mode does not guarantee that the steering wheel is
perfectly straight, as the rear axle reference is not calculated.
The service window is accessed by pressing key F8 from the wheel aligner program starting
window.
A list of the options available is displayed:

• Demo;

• Technical Assistance;

• Job Count (if enabled in the wheel aligner general set-up – F4 from the Logo page).
Select an option and press F3 to access the chosen procedure.
Select the "Demo" option and press key F3 to enable/disable operation of the program in demo
mode. Target cannot be used in demo mode, all values viewed are random. Enabling/disabling
of this function is indicated by an icon (red
working window.
This window is used to check the correct operation of the targets when they are used on a vehicle.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F10 goes back to the starting menu window.
Window for use by the technical support service only.
Users are urged not to access this window. Improper use of the procedures in this program
section may cause aligner malfunctions.
This option is visible only if previously enabled in the wheel aligner general set-up.
To access the "Job Count" window, enter the password (the password is not indicated in this
manual for security reasons).
If interested in this option, please request the password from the support service.
The total count of the jobs performed is indicated in the left section of the two-section window
(Fig. 29). In the left section, the job count per working day is displayed together with a calendar
from where to choose a day to be viewed.
Three boxes are located above the calendar, where the desired day, month and/or year can be
selected for rapid selection of the date searched. After setting the date, confirm the selection by
pressing the "Enter" key
This window behaves like message windows, where the active function keys are in the window,
whereas the function bar keys are disabled.
The following keys are active in this window:
- F2 returns to the previous window
- F4 resets the overall job count to zero.

SERVICE PROCEDURE WINDOW

X

Target test

Technical Assistance

Job count

Demo
over a white car) in the top right-hand corner of the
82