Vehicle Preparation For Setting Operations; Switching The Aligner On And Off; Measuring Unit; General Considerations - SICE A 92 Manual De Instrucciones

N) Axle values difference: window that indicates the value and the databank reference of the
difference of the right and left values of the read angle. This window is shown only then
there is a reference value in the databank.
O) Working area: section of the screen that shows the information of the job being done.

VEHICLE PREPARATION FOR SETTING OPERATIONS

In order to perform wheel alignment correctly, all parts of the vehicle must be in compliance with
the manufacturer's specifications; it is especially important to check the tyre pressure and
eliminate play in bearings and ball joints.
Position the vehicle over an inspection pit or on a lift that is correctly equipped for alignment
operations. Make sure that the turntables and oscillating footboards are locked.
Mount the self-centering clamps on the wheels and lock them on the rim using the handles.
For rims made of steel or with projecting edges, the clamps should be secured from the inside
(1, fig. 6A); in the case of alloy rims secure the clamps from the outside (2, fig. 6A), for rims with
plastic covers secure the clamps from the inside with the pins reversed (3, fig. 6A).
If necessary, you can tap the wheel clamps gently with the hand to fit the clamp nose between
the rim and the tyre bead.
For other types of support clamps with a jaw or dedicated closing device, follow the instructions
attached and inserted in the specific package.
Mount the "small" targets on the front wheels and the "big" targets on the rear wheels.
Set the rear switch to "I" (On) to turn the aligner on.
Then wait until the starting screen is displayed (fig. 7).
To correctly switch off the aligner:
- go back to the starting screen (fig. 7)
- press the "F10" key;
- confirm by selectingthe symbol "√" ;
- wait until the computer is off (black screen) and set the rear switch back to "0" (Off).
Never switch off the machine when there is a page other than the logo page because
such an action might damage the PC.
If this should occur, when the PC is switched back on, the software will request the user
to press any key to perform the "SCANDISK" operation.
This operation is used to check that the PC has not been damaged and, if necessary, to
update some files that might have been damaged.
At the end of the process, if the program reboots normally, then no problems have
occurred. Instead, if any message appears that blocks the program start-up procedure,
contact the nearest technical assistance centre.
The equipment simple interface makes operation quick and easy to learn. The operating
procedures are generally standardised throughout the program, as summarised below.

SWITCHING THE ALIGNER ON AND OFF

GENERAL CONSIDERATIONS

Measuring unit

ATTENTION
62