Starrett S7010 Manual De Instruccion página 108

CUTTING IN THE CENTER OF MATERIAL:
To perform a cut in the center of the material, without starting by one of the
edges, the user must perform a through hole, whose diameter is from 1 to 2
mm greater than the width of the blade.This procedure is the most correct
and safe for the user (fi gure 10).
1. DRAW lines to the desired opening to be cut;
2. MAKE a hole for passage of the blade or close the line;
3. CHECK THAT the tip of the blade passes completly through hole, and
that the useful length thereof is greater than the thickness of the material
to be cut;
4. ENTER with the Blade in the
hole of the material;
5. HOLD fi rmly the machine
and START the cutting;
6. PERFORM the cutting until
the removal of the desired mate-
rial;
7. When fi nished cutting, TURN
OFF the machine and WAIT for the
cool tool before handling it.
108 S7010
ENGLISH
FIG 10