Mounting The Bar And Chain - Stihl HT 102 Manual De Instrucciones

Mounting the Bar and Chain

Removing the Chain Sprocket Cover
Unscrew the nut and remove the
N
chain sprocket cover.
1
2
Turn the screw (1) clockwise until
N
the tensioner slide (2) butts against
the right end of the housing slot.
HT 102, HT 103, HT 132, HT 133
Fitting the Chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain – start at the bar nose.
N
5
1
3
4
Fit the guide bar over the screw (3)
N
and engage peg of tensioner slide in
the hole (4) – place the chain over
the sprocket (5) at the same time.
Turn the tensioning screw (1)
N
counterclockwise until there is very
little chain sag on the underside of
the bar – and the drive link tangs are
engaged in the bar groove.
Refit the sprocket cover and screw
N
on the nut fingertight.
Go to chapter on "Tensioning the
N
Saw Chain".
English
17