Safety Regulations - SICE S 63 E Manual De Instrucciones

diameter and 14mm outer diameter must be fastened to the notched union using the
clamp provided with the machine.
CAUTION
Non-compliance with the instructions and danger warnings can cause serious injuries
to the operator or other persons.
Do not operate the machine until you have read and understood all the danger/warn-
ing notices in this manual.
In order to operate the machine correctly, it is necessary to be a qualified and authorised
operator, able to be trained and to know the safety regulations. Operators are expressly
forbidden from using the machine under the influence of alcohol or drugs capable of
affecting physical and mental capacity.
The following conditions are essential:
- the operator must be able to read and understand the contents of this manual;
- have a thorough knowledge of the features and characteristics of the machine;
- keep unauthorised persons well clear of the working area;
- make sure that the machine has been installed in compliance with all relevant standards
and regulations in force;
- make sure that all machine operators are suitably trained, that they are capable of using
the machine correctly and safely and that they are adequately supervised during work.
- do not touch power lines or the inside of electric motors or any other electrical equip-
ment before making sure that they have been powered off;
- read this booklet carefully and learn how to use the machine correctly and safely;
- always keep this user manual in a place where it can be readily consulted and do not
fail to refer to it.
CAUTION
Do not remove or deface the DANGER, WARNING, CAUTION or INSTRUCTION decals.
Replace any missing or illegible decals. If one or more decals have been detached or
damaged, they can be replaced by your nearest manufacturer dealer.
- When using and carrying out maintenance on the machine, observe the unified indus-
trial accident prevention regulations for high voltage industrial equipment and rotating
machinery.
- Any unauthorised modification to the machine releases the manufacturer of all liability
in the event of damage or personal injury resulting from said modification. Specifically,
tampering with or removal of the machine safety devices is a breach of the regulations
relating to Safety at Work.
CAUTION
During work and maintenance operations, always tie back long hair and do not wear
loose clothing, ties, necklaces, wristwatches or any other items that may get caught
up in the moving parts.
Operator's Manual S 63 E - S 63 E C

SAFETY REGULATIONS

83