Corghi EM 7240 Manual De Uso página 62

Fitting the external sensor and relative support (if available)
- Fix the external sensor support to the wheel balancer body using the three screws
supplied with the machine (A, Fig.6b);
- Insert the external sensor pin (B, Fig.6b) in the sensor support bush (C, Fig. 6b);
- Screw the screw (D, Fig. 6b) bringing it closer to the sensor pin without touching it;
- Make sure that the external sensor rotates freely;
- Connect one of the sensor's cable connectors to the socket located on the sensor body
(H, Fig. 6a);
- Tape the cable to the sensor support (F, Fig. 6b) so that it is never tensioned;
- Connect the sensor cable connector to the machine rear panel (G, Fig.6b).
IMPORTANT: after installing the external sensor, calibrate the sensor as described in
the paragraph "Width sensor calibration".
62
6a
6b
EM 7240 Operator's manual