Wheel Spin (With Guard); Selection Of Adhesive Weights Application Position - Corghi EM 7240 Manual De Uso

WHEEL SPIN (with guard)

Wheel spin takes place automatically when the guard is lowered, or can be triggered by
pressing the START key with the guard lowered.
A special safety device stops rotation if the guard is raised during the spin; in this case,
the "A Cr" message is displayed.
WARNING
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
WARNING
Never raise the guard before the wheel has come to a stop.
WARNING
If the wheel keeps spinning permanently due to a fault on the machine, switch off the
machine using the main switch or disconnect the plug from the power supply board
(emergency stop) and wait until the wheel stops before raising the guard.
SELECTION OF ADHESIVE WEIGHTS
APPLICATION POSITION
The machine makes it possible for the operator to select where the adhesive weight
should be applied based on his needs.
To select this configuration, proceed as described below:
• Press either of the two keys
key. This selects the service programme 89 shown on the left display. The
flashing "Ent" message will appear on the right display.
- Press the
• The message ALU will appear on the left display, whereas the message H.XX will
appear on the right display, where XX indicates the selection of the adhesive weight
application enabled on the machine.
• The key can be used to change this configuration to H3, H6 or H12.
• Press to confirm the selection made and exit the function.
- For the application of the balancing weights, refer to the following table:
78
key to confirm.
and then, within two seconds, press the
EM 7240 Operator's manual