- Measure the width of the rim using the calliper provided (Fig. 11).
- Modify the width value displayed by pressing the keys
number is set.
The WIDTH can be set in millimetres or the values already set can be converted from
inches to millimetres by pressing the
Keep the
set values.
Wheel data entry for wheel balancers version with automatic
sensor with external sensor (width) "if present"
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm (A, Fig. 7) into contact with the inner side
of the rim as shown in fig. 10/10a and at the same time bring the automatic external
measuring arm (B, Fig. 7) into contact with the outer side fig. 11a.
74
buttons pressed to rapidly increase or decrease the previously
11
button for five seconds.
11a
EM 7240 Operator's manual
until the desired