Bobbin Thread Preparation; Winding The Bobbin Thread - JUKI HZL-G220 Manual De Instrucciones

Bobbin thread preparation

Attention
Turn OFF the power switch before the bobbin is taking out and/or put into the bobbin case.
Taking out the bobbin
1
Open the hook cover.
2
Take out the bobbin.
* If the bobbin has too little thread, do not use it as the
thread will get tangled.
* Use only the designated bobbin. Other bobbins may cause
malfunction.

Winding the bobbin thread

1
3
2
1
Spool pin
Thread the guide 1 , then thread the thread guides
2 and 3 (guides in the circle) for bobbin winding.
2
4
Bobbin winding
shaft
Set the bobbin on the bobbin winding shaft 4 .
14
Hook cover
Thread guide
4
Setting thread spool
Spool Cap
Spool Cap
Place a thread spool to spool pin and a spool cap
onto the spool pin.
* Do not use the thread cone with a small amount of
thread. This may cause thread tangling and/or the thread
coming out of the eye of the needle when starting to
sew.
3
5
Press the bobbin winding regulator 5 towards
the bobbin. Start/stop button now becomes
orange. When start/stop button is pressed,
machine starts to wind the bobbin thread.
4
When winding is finished, the shaft stops
automatically, the bobbin winding regulator
moves to right and return to the original position.
Remove the bobbin from the bobbin winding
shaft and cut the thread.
* Bobbin winding will automatically stop even while
winding, when the winding speed is reduced due to
a load to the bobbin winding motor caused by thread
tangling.
Small spool
Large spool
Bobbin winding regulator
5