Bartacking - JUKI HZL-G220 Manual De Instrucciones

Bartacking

Turn OFF the power switch before
Attention
replacing the presser foot.
Bartacking is used to reinforce the part of the seam that is
likely to ravel.
* The length of the bartack is determined by pushing the re-
verse stitch button, but it will automatically make a u-turn
when it reaches the maximum of 20 stitches.
* If the presser foot cannot be parallel to throat plate, use filler
fabric or cardboard.
Example of use
Trousers and skirt
1
10 cm
Pass the needle thread through the presser foot.
2
Fabric
Place the fabric under the presser foot.
34
Pattern
Practical 20
No.
Manual
Presser
buttonhole
foot
presser foot (I)
Bag Pocket
3
Starting
point
Start sewing.
Push the start/stop button and the machine starts to sew
straight stitches.
4
Turning
point
When it comes to the turning point push the
reverse stitch button.
The machine goes back to the starting point by sewing
straight stitches and then it sews zigzag stitches to the
point where the reverse stitch button is pushed.
5
Lock
stitches
When the machine comes to the sewing end
point, push the reverse stitch button.
The machine sews lock stitches and stops.
To sew a bartack of the same length again...
when the length of the first bartack has been
memorized,
● When the start/stop button is
pushed, the machine starts
to sew and makes a u-turn
automatically at the same
point as the first bartack.
* If you want to change the memorized length of the
bar tack, please select stitch pattern again.
● When it comes to the sewing
end point, push the reverse
stitch button.
Start/stop button
Reverse stitch button