Function Of Operational Buttons; Start/Stop Button - JUKI HZL-G220 Manual De Instrucciones

Function of operational buttons

Start/stop button

When pressing this button, machine starts
to sew slowly and then up to the speed set
by speed controller. When pressing this
button again, machine stops with needle at
its down position. Color of button indicates
machine status.
Green: Ready to start and/or while sewing
Red: Not ready to start (When it is pushed
in red condition, needle moves by one
stitch.)
Orange: Machine is in bobbin winding con-
dition.
Reverse stitch button
While pressing this button,
machine sews reverse (lock stitch).
Speed controller
While sewing, speed can be adjusted.
G220
Thread trimming button
After sewing, press this button to trim both threads automatically.
Notes for thread trimming:
1. Do not use thread thicker than No.30.
2. After trimming, the stitch can be done without pulling up bob-
bin thread.
3. When sewing again after thread trimming, if you pull up the
bobbin thread again and place it underneath the presser foot
together with needle thread, you can avoid birds nest on the
wrong side of the fabric.
4. Regularly clean the machine (refer to page 49), as dust in the
area of the thread trimming unit may cause malfunction.
G120
Needle up/down button
When machine stops, press this button to change the needle posi-
tion.
(When the needle is up, the needle moves down and vise versa.)
Even when the presser foot is raised, be aware that the
needle moves up or downward.
7