Connecting To The Power Supply - JUKI HZL-G220 Manual De Instrucciones

Connecting to the power supply

• Disconnect the plug and turn off the power switch (turn to "O") that always sewing machine is
Warning
not to use. Otherwise, it may cause electric shock and/or fire.
Power switch
Machine-socket-inlet
Power switch
Machine-socket-inlet
Foot-controller-jack
8
Socket-outlet
Plug
Cord-connector
Cord-connector
Socket-outlet
Plug
Foot-controller-plug
Foot controller
Not-using foot-controller that using start/stop-button:
1. Turn OFF the power switch (turn to "O")
2. Insert cord-connector into machine-socket-inlet.
3. Insert plug into socket-outlet.
4. Turn ON the power switch. (Turn to "I")
WARNING (For U.S.A.,Canada only)
This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of electric shock, this plug is intended to
fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not modify the plug in
any way.
Using the foot-controller:
1. Turn OFF the power switch (turn to "O")
2. Insert the foot-controller-plug into the foot-controller-jack.
3. Insert cord-connector into machine-socket-inlet.
4. Insert plug into socket-outlet.
5. Turn ON the power switch. (Turn to "I")
* When the foot controller is plugged in, the start/stop button
cannot be used to start sewing.
Start button: Can not operate to start sewing.
Stop button: Can operate to stop sewing.
ON
OFF
Operating power switch:
Turn OFF the machine, set the
power switch to "0".
Turn ON the machine, set the
power switch to "I".