Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of indoor unit
2. Make the power connection wire go
through the cable-cross hole at the back
of indoor unit and then pull it out from
the front side.
3. Remove the wire clip; connect the power
connection wire to the wiring terminal
according to the color; tighten the screw
and then fix the power connection wire
with wire clip.
NOTE:
Please refer to the actual one.
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
NOTE:
•
All wires of indoor unit and outdoor unit should be connected by a professional.
•
If the length of power connection wire is insufficient, please contact the supplier for a new
one. Avoid extending the wire by yourself.
•
For the air conditioner with plug, the plug should be reachable after finishing installation.
•
For the air conditioner without plug, an air switch must be installed in the line. The air
switch should be all-pole parting and the contact parting distance should be more than
3mm.
09, 12K, 18K, 24K Heat pump type:
blue black brown
Outdoor unit connection
The wiring board is for reference only.
38
cable-cross
hole
power connection wire
2
3
N(1)
yellow-
green
GB
Publicidad
Tabla de contenido
