Troubleshooting - Polaris Quattro Manual De Uso

Troubleshooting

Problem
becomes tangled.
Cleaner hangs up on steps or other
obstacles for longer than
Thrust jet sprays too much
water out of pool.
Cleaner does not clean
14
Solution
Hose assembly 1. Remeasure the hose to verify that it is adjusted to
the proper length for the pool shape.
2. With the cleaner operating, check that the hose
swivels and the hose connections turn freely.
3. Ensure the hose is floating and the hose floats
are positioned properly. Position the first float (k)
up against the feed hose connector (j) and then
space hose floats 1-3 ft (30-90 cm) apart.
4. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
refer to Section 7 Adjust Wheel Speed.
5. Straighten the hose assembly by laying it out flat
in the sun.
1. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
3 minutes. refer to Section 7 Adjust Wheel Speed.
2. Check for debris in the filter canister and clean, if
necessary.
3. Ensure the hose is floating and the hose floats
are positioned properly. Position the first float (k)
up against the feed hose connector (j) and then
space hose floats 1-3 ft (30-90 cm) apart.
4. Adjust the thrust jet. Refer to Section 8 Fine
Tuning.
5. Remove unnecessary pool hardware or install
a Ladder Guard Kit (part # G21) from a Polaris
dealer.
6. Install a Back-Up Valve accessory (part # G62,
black or part # G52, white) from a Polaris dealer.
Additional hose nuts and swivel may be required.
Position the back-up valve and its adjacent hose
float 6-8 ft (1.8 - 2.4m) away from the cleaner.
Check the thrust jet position and adjust thrust jet
flow, if necessary. Refer to Section 8 Fine Tuning.
1. Ensure the hose length is adjusted to the proper
the entire pool. length for the pool shape. Refer to Section 3
Adjust Hose Length.
2. Adjust the thrust jet to improve coverage. Refer to
Section 8 Fine Tuning.
®