Error Indicators
When this printer malfunctions or jams etc., the type of problem is indicated by a buzzer
and by lit or flashing LED on the operating panel.
In error status, the error indication can be cancelled by pressing the FEED switch.
Error indicator table
Type of Error
Paper end
POWER
PAPER OUT
ERROR
Paper near end
POWER
PAPER OUT
ERROR
Rear/front cover
POWER
open
PAPER OUT Depends on status
ERROR
Head hot
POWER
PAPER OUT Depends on status
ERROR
HP abnormal
POWER
PAPER OUT
ERROR
Black mark
POWER
abnormal
PAPER OUT
ERROR
Cutter abnormal
POWER
position detection
PAPER OUT
ERROR
Hardware abnormal
POWER
RAM read-write
PAPER OUT
ERROR
Hardware abnormal
POWER
FROM read-write
PAPER OUT
ERROR
24V abnormal
POWER
PAPER OUT
ERROR
• There are no RS232C communication error or front cover opened/closed detection
indicators.
• If the buzzer setting is OFF in Soft SW Setting Mode, the buzzer does not sound.
: Lit,
: Off
LED indicator
Lit
During printing, printing stops and the printer goes
offline. Replace the paper and close the cover to
Lit
return the printer online.
Off
Lit
In centro-interface, when the Paper Near-End on the
Soft SW is set as enabled, PE, FAULT are output and
printing continues. When it is set as disabled, nothing
Off
is output and printing continues.
Lit
During printing, printing is immediately stopped and
the printer goes offline. Close the cover to restore the
printer to online status.
Lit
Lit
Cooling starts. After the temperature has fallen, it is
automatically restored and printing restarts.
The buzzer continues to sound until the error is
cancelled by the FEED switch.
The printer goes offline. Remove the paper jam or
other problem and press the FEED switch to restore
the printer to online status.
The buzzer continues to sound until the error is
cancelled by the FEED switch.
Off
Turn off the power then turn it on again. If the error
continues, notify the dealer where you purchased the
printer or service personnel after turning off the power.
Off
Off
Off
Operation and restoration method
English
41