Frequency Band Selection - PRESIDENT TAYLOR IV Manual Del Usuario

UK FM mode selected (only in U configuration / ENG) (blinks
PA
in mode)
ROGER BEEP function activated
BP
KEY BEEP function activated
Automatic Squelch Control activated
VOX VOX function activated
SCAN function activated (the dot blinks)
MENU mode activated
Indicates the channel or band selected
Indicates frequency or menu
6) CB/PA ~ CB TB
3 position switch : CB, CB TB and PA.
CB/PA
CB PA
Switch between and (Public Address) mode.
An external optional speaker can be connected to the unit to the PA.SP. jack
on the rear panel. (D). LCD indicates
mode (AM/FM/UK).
For more details on operating in PA mode, see the PA SETTING menu on
page 37.
CB TB
Allows the activation of the TALKBACK function.
TALKBACK function
hear
This function allows you to
or external speaker connected to the EXT jack. MS. (C).
When activated, LCD shows the TALKBACK level during 3 seconds.
TALKBACK level
Press and hold the PTT switch (13) then turn the rotary CH knob (3) to
crease decrease
(clockwise) /
TALKBACK. Release the PTT switch (13).
7) NB/ANL - HI-CUT FILTERS
3 positions switch: Low position: no filter is activated. Central position: only
ANL and NB filters are enabled. High position: all filters (ANL, NB and HI-CUT)
are activated.
PA
mode by blinking the modulation
your own modulation in the optional internal
(counterclockwise) the volume level of the
NB: Noise Blanker / ANL: Automatic Noise Limiter. These filters allow reducing
back ground noises and some reception interferences.
HI-CUT: Cuts out the high frequency interferences and has to be used in
accordance with the reception conditions.
Note: ANL filter works only in AM mode
8) PRIORITY CHANNELS
Priority channels will be automatically
3 positions switch: EMG1/ Priority channel 1 is activated. EMG2 / Priority
channel 2 is activated. OFF / No priority channel is activated.
The default priority channels are channel 9/AM (EMG1) and channel 19/
AM (EMG2).
See the EMG SET 1 and EMG SET 2 menus page 37 to
Note: Activating a priority channel prevents changing the modulation
mode (AM / FM / UK), scanning the channels or activating the
If the KEY BEEP function is activated, an error beep sounds. "EMG" and the
channel blink to indicate unauthorized handling. Turn the switch (11) to the
OFF position to use these functions.
9) F ~ FREQUENCY BAND SELECTION
F
(short press)
Enter MENU. See § MENU page 35.

FREQUENCY BAND SELECTION

See § FUNCTION TURNING ON THE UNIT page 35.
10) MODE ~ VOX
MODE
(short press)
Press MODE key (10) to
mode is displayed on LCD.
Your modulation mode has to correspond to the one of your correspondent.
- Frequency Modulation / FM: for nearby communications on a flat open
field.
in-
- Amplitude Modulation / AM: communication on a field with relief and
obstacles at middle distance (the most used).
In U configuration only: The MODE key (10) allows to
CEPT frequency band. "UK" is displayed when the ENG frequency band
is selected. When the CEPT frequency band is selected, "UK" disappears
from the display (see table on page 54).
34
selected
by switching this key (8).
set
priority channels.
select
the modulation mode: AM or FM. Selected
select
PA
mode.
the ENG or