Additional Thermostat; Additional Thermostat Functioning With Stby Active; Additional Thermostat Operation With Deactivated Stby; Additional Thermostat Installation - Dal Zotto Valli idro Manual Del Usuario

ADDitiOnAL therMOStAt

n.b. : installation must be performed by an authorised technician
It is possible to thermostat a room adjacent to the room where the stove is positioned: just connect a thermostat following
the procedure described in the next point (it is recommended to position the optional mechanical thermostat at a height of
1.50m from the ground). Stove functioning with the external thermostat connected in the STBY clamp can be different on the
basis of the activation or deactivation of the STBY function.
the Stby clamp leaves the factory jumpered, therefore it is always with closed contact (on request).

ADDitiOnAL therMOStAt functiOning With Stby Active

When the STBY function is activated, the
contact/temperature reached), the stove will switch off. As soon as the contact or external thermostat passes to the "not
satisfied" status (closed contact/temperature to reach) it will re-ignite.
note: stove functioning depends on the temperature of the water inside the same and relative factory restrictions set.
if stove is in h Off mode (water temperature reached), any additional contact or thermostat request will be ignored.

ADDitiOnAL therMOStAt OPerAtiOn With DeActivAteD Stby

When the STBY function is deactivated, the
When the contact or external thermostat is not satisfied (open contact/temperature reached), the stove will go to minimum.
As soon as the contact or external thermostat passes to the "not satisfied" status (closed contact/temperature to reach) the
stove will start to work again at the pre-set power.
note: stove functioning depends on the temperature of the water inside the same and relative factory restrictions set.
if stove is in h Off mode (water temperature reached), any additional contact or thermostat request will be ignored.

ADDitiOnAL therMOStAt inStALLAtiOn

Š Switch the appliance off using the master switch positioned on the rear of the stove.
Š Remove the plug from the socket.
Š Refer to the electrical layout to connect the two thermostat cables onto the relative clamps positioned don the rear
of the machine, one is red and the other black (STBY clamp). every model can have a different position of the relative
clamps in the rear of the machine. the image is given as an example.
fOr StAnDby ActivAtiOn, refer tO the "uSer Menu" chAPter
The STBY and AUX
clamps, found at the
back of the stove
(except for the Frida
Model), can be noted
in the diagram at the
side
Follow the instructions
described below for
the connection to the
STBY and AUX clamps.
remove the right
panel

AuX

Connection reserved for Dal Zotto conveyed waves accessories. Contact the dealer for further details
66
LED flashes. When the contact or external thermostat is not satisfied (open
LED is fixed.
2272575
I2 GND
A
U
X
Follow the instructions
described below for
the connection to the
STBY and AUX clamps.
remove the right
panel
Pass the Stby and
AuX wiring through
the indicated cable
gland
| engLiSh