NO FUEL:
the stove can never develop a suitable flame, tending to remain very low even at high powers.
at minimum power the stove tends to almost switch-off taking the stove into "
when the stove displays the "
EXCESS FUEL:
the stove develops a very high flame even at low power.
the panoramic glass is very dirty, obscuring it almost totally.
the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only
burned partially.
The regulation to be performed is a percentage. Therefore a modification of this parameter will lead to a proportional
variation of all stove feeding speeds. Feeding is from -30% to +20%.
Follow the procedure on the display to perform this adjustment:
CONTROLS PROCEDURE
Press the key 6, Set cLOcK will appear.
Press key 2 several times until "uSer" is displayed
Press key 6.
"Set therMOStAt" will appear
Press key 2 until "PeLLet" is displayed.
Use key 4 to increase and 5 to decrease the load during the WORk
phase.
Press key 6 to confirm and 1 to return to the previous menus
back to the initial status.
v1-fAn
This menu allows (in models where provided) adjusting the front fan speed percentage.
CONTROLS PROCEDURE
Press the key 6, Set cLOcK will appear.
Press key 2 several times until "uSer" is displayed
Press key 6.
"Set therMOStAt" will appear
Press key 2 until "v1 fAn" is displayed.
Use keys 4 to increase and 5 to decrease
Press key 6 to confirm and 1 to return to the menu
back to the initial status.
StAnD-by
The Stby function is used if immediate stove switch-off or modulation via additional external thermostat is desired.
CONTROLS PROCEDURE
Press the key 6, Set cLOcK will appear.
Press key 2 several times until "uSer" is displayed
Press key 6.
"Set therMOStAt" will appear
Press key 2 until "StAnD by" is displayed.
Use keys 4-5 to enable/disable.
Press key 6 to confirm and 1 to return to the menu
back to the initial status.
" alarm, there may be non-burned pellets inside the burn pot.
nO PeLLetS
| engLiSh
" alarm condition.
nO PeLLetS
1
69