BQS BTW123 Manual De Uso página 12

2. SEAT PARTS AND FITTINGS
A. Cover.
B. Ergo seat cushion for group 1.
C. Harness straps.
D. Harness pads.
E. Locking buckle.
F. Childs´s seat base.
G. Harness adjuster strap.
H. Armrest.
I. Headrest adjuster lever.
J. Belt hook.
K. Harness strap slot.
L. Metal harness connector.
M. ISOCLICK Anchors.
N. ISOCLICK button to uninstall the system (Red)
O. Backrest.
3. ISOCLICK ANCHORS INSTALLATION. GROUPS 1, 2 AND 3.
WARNING
To install the chair first install the ISOCLICK anchors and then each
group according to its individual installation.
1. Remove the anchorage rod protectors from the vehicle seat if
present (3.1).
2. Extract the ISOCKLICK Anchors
180 degrees from the base of the chair (3.2).
3. Installez les ancrages à travers les rainures de la tapisserie entre
le dossier et le siège du véhicule jusqu'à entendre un "Click" qui
signifie que les ancrages sont correctement installés et verrouillés
avec le siège du véhicule (3.3, 3.4 y 3.5).
4. To uninstall ISOCLICK anchors press the red button
ISOCLICK anchors to extract the chair from the vehicle seat.
22
To install the chair it is first necessary
to install the ISOCLICK anchor.
M from the chair by rotating them
N and pull the
BTW 123
4. INSTALLING CHILD SEAT. GROUP 1.
Only suitable for Group 1, approx.
WARNING
9 months to 4 years of age (9-18 Kg.)
Make sure you have installed the ISOCLICK anchors before installing
the chair as indicated in Group 1.
1. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (4.1).
2. Raise the rear of the elevator upholstering ensuring you have
extracted the safety buckle
3. Pass the lap portion of the vehicle safety seat belt over the
elevator making sure that the tape is positioned as shown in fig.
4.4. passing it in front of the safety buckle E.
4. Return the elevator trim to its original position by affixing the Velcro
to ensure that it does not lift up and once more passing the safety
buckle E through this. The belt should be below the upholstery
(4.5).
5. Connect the belt to the buckle, making sure you hear a "Click"
and tighten the belt diagonally to ensure maximum tension of the
abdominal portion (4.6).
6. Thread the belt through the top of the back as shown in fig. 4.7. Be
sure to pass the tape through the belt guides on both sides, and
stretch the chest portion of the belt to reduce slack in the tape.
E from its sheath (4.2 & 4.3).
www.babyqs.com
EN
23