Publicidad
Mic input jack
Accepts connection of a microphone.
If a cable is plugged into the line input jack, audio will not be input through
the mic input jack.
Set the mic type select switch
the connected microphone is a dynamic microphone or a plugin-powered miniature
condenser microphone.
Stereo microphones are supported; use a stereo mini-type cable to make connections. If
you use a monaural microphone, set the Setup mode "10 Input Select" setting to
MONO. For details on this setting, refer to "System settings (Setup mode)" (p. 54).
Line input jack
If you want to input an audio signal from an audio device or electronic musical
instrument into the R-1, use a stereo mini-plug cable to connect it to this jack.
Mic type select switch
Set this switch to the appropriate position according to the type of microphone you've
connected to the mic input jack
Use this setting if you've connected a dynamic microphone.
DYN
If you're using the internal microphone, set this to DYN.
Use this setting if you've connected a miniature condenser microphone that re-
quires a power supply. You must use a "plug-in powered" microphone. This jack
supplies a voltage of 2 V.
CND
* If this switch is set to CND, do not connect any microphone or device other than
a "plug-in powered" microphone. Any other type of microphone or device may
be damaged.
Input volume
This adjusts the input volume of the sound from the built-in mics
, or line input jack
Use the procedure described in "Adjusting the input level" (p. 30) to adjust this while
watching the input level.
USB connector
You can use the included USB cable to connect this connector to your computer.
If the R-1 is connected to your computer, the song files you record can be transferred or
copied to your computer. You can also transfer or copy MP3 or WAV files from your
computer to the R-1 so that these files can be played on the R-1.
This connector supports USB 2.0 (hi-speed USB), allowing files to be transferred
rapidly.
If you want to connect the R-1 to your computer, please refer to "Connecting the R-1
to your computer" (p. 44).
When your computer has correctly recognized the R-1, the R-1's display will indicate
Connected via USB.
While the R-1 is connected to a computer, all functionality of the R-1 (other
than its power switch) is disabled; operating the buttons or switches will not
do anything.
to the appropriate position depending on whether
.
.
The R-1's controls and connectors
, mic input jack
1
15
Publicidad
