Operation; Modes; Angle Settings - Holzmann KAP 255XJL Manual De Instrucciones

13

OPERATION

13.1

Modes

NEVER FORGET: Switch the machine off (38) and disconnect the machine prior
to any adjustment, maintenance or check activities from the power supply.
This prevents the hazard of unintended starting-up.

13.1.1 Angle settings

Tilt adjustment:
 Loosen the fixing knob (16).
 Set the saw arm in order that the tilt angle indicator (11) points exactly at 0° of the measur-
ing scale (12).
 Fix the saw arm in this position by tightening the fixing knob (10).
 Bring the saw arm into the lower position and lock it with the interlock knob (13).
 Attach an exact angle measuring device to saw blade side and ground plate. They should
have an exact angle of 90°.
Swing angle adjustment:
 Loosen the fixing knob (13), operate the fixing lever and swing the saw arm aggregate to the
0° position, let it click into place. You can see the angle at the measuring scale (15).
 Swing the saw arm into the lower position and lock it with the interlock knob (13).
 Attach an exact angle measuring device to saw blade side and the left back fence (7). They
should have an exact angle of 90°.
 If not, you need to adjust the back fence guide with the back fence adjustment screws so
that angle between saw blade and fence equals 90°.
 Repeat the procedure with the right side back fence.
Adjust the cutting depth
Fig. 13:
Finally you need to check the cutting depth of the saw.
Swing the saw arm down into lowest possible position and check if it
touches the ground plate.
The depth stop should be already preset so that the blade reaches
into the cutting line slit but has a distance to the ground plate of at
least 5mm.
If necessary adjust the depth stop pin (27).
Laser
The Laser marks the cutting line. After having set all angles
and cutting depth, you should fine-tune your laser.
Attach the workpiece to the back fence, fix it with the
downholder.
Perform a slot cut on the workpiece so that it gets not cut
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
Zug-, Kapp-, Gehrungssäge / Profi mitre saw / Manual de instrucciones/Mode d´emploi
OPERATION
Seite 34
KAP 255 XJL