Install; Unpack; Installation - Fri-Jado CSD 180 Hot Instrucciones De Manejo

Install

3.
3.1.

Unpack

1. Remove all parts from the unit.
2. Remove the foil from all metal parts.
3. Remove all packaging materials from the unit.
4. Check the unit for damage.
5. Make sure that all parts that belong to the model
you have ordered are present.
6. Read the manual before proceeding.
If any parts are missing or damaged, contact your supplier.
3.2.

Installation

WARNING
•
There should be at least 100 mm clearance between the sides and other
equipment or walls.
•
Position the unit flatly on a sufficiently sturdy base using a spirit level. Here take
the weight of the unit into account.
Follow the procedure below when storing a unit that will not be used for some time:
•
Thoroughly clean the unit.
•
Pack the unit dustproof.
•
Store the unit in a dry place.
Find a suitable place for the unit. Points of interest:
•
The products in the unit must be well visible.
•
There must be sufficient room to operate and maintain the unit.
•
Make sure that the unit is accessible for maintenance and service activities.
•
Be sure that the environmental temperature is not less than 20 °C and not more than 30 °C.
•
In connection with the danger of short circuit the unit is not suited for use in a rainy or very
moist environment.
1. Clean the inside, the removable parts and the accessories thoroughly with soapsuds before
putting the unit into use.
2. After cleaning, wipe the unit with a cloth moistened with clean water to remove soapsuds residues
and then dry the entire unit.
3. Attach all (optional) parts and/or accessories.
4. Insert the plug into the socket.
5. Fill the water tray with clean cold water. Preferably use softened water.
•
The presentation plateaus have different dimensions. A mark has been provided for
easy placement. The bottom plateau has been marked with one groove, the middle
plateau has two grooves and the top plateau three.
•
The water tray can be placed on the customer side as well as on the service side.