Switching Off; Charging The Battery - AUtec Modular Serie Manual De Usuario

LIMKDPU0

SWITCHING OFF

The transceiving unit should be
switched off each time work is stopped
by turning the ignition key to "O" and
extracting it (always put the key in a safe
place).
The unit may also switch off if the battery is
not sufficiently charged and/or when the
radio remote control is not used for more
than 3 and half minutes.
STOPPING
!
The STOP button
should be used when it
is necessary to stop the
machine immediately in
order to check any
danger condition.
To stop the machine immediately, press
the STOP button.
To start working again, after having
made sure that the working conditions
are safe, turn the STOP button in the
direction indicated to deactivate it and
repeat the starting procedure.

CHARGING THE BATTERY

To recharge a flat battery, proceed as
follows:
1. Insert the battery into its proper
battery charger, which should be
positioned in an area having a
temperature of between +5°C and
+45°C. The battery now starts
charging, a state signalled by the
lighting up of the "CHARGE" pilot
light.
2. After a maximum of 3 hours the
"CHARGE" indicator switches off: the
battery is fully charged. Remove the
battery from the charger (if the battery
is not removed, charging continues in
maintenance mode).
Page 11