AUtec Modular Serie Manual De Usuario página 37

LIMKDPU0
When the machine is correctly controlled by the radio remote control, proceed as indicated in
the following flow chart, starting from the left when dealing with a transceiving unit with
display, and starting from the right when dealing with a transceiving unit with LEDs only:
MK10 DF
unit with
display
Do no characters
appear on the
display?
NO
Does "- - - - - -"
appear on the
lower line
of the display?
NO
Does the phrase
"NO DATA" appear
on the lower line
of the display?
YES
!
BE CAREFUL when activating commands during diagnostic operations
or when no signals are present because the machine is controlled
normally and improper use can cause danger situations.
RECEIVING UNIT DIAGNOSTICS
YES
CALL
SERVICE
Verify the radio link
as indicated in the
p a r a g r a p h
YES
"DISPLAY OR LED
OPERATION".
Does the problem
continue?
YES
Change the radio
remote control
frequency (refer to the
paragraph 8
"Frequencies" in this
manual).
Does the problem
continue?
YES
Carry out the
diagnostic
operations
relative to the
DATAFEEDBACK
TRANSMITTER
MK10 DF
unit with
LEDs
Does the machine
send at least one
alarm signal?
Are the LEDs
7
present always unlit
or do they light up in
an irregularly?
If the problem
persists,
CALL
SERVICE
NO
YES
NO
YES
Page 17